Laterals
45° Laterals, Tapered Reducing Laterals 30° Laterals & Saddles
Available in any angle. Standard is 45°
45° Lateral
(L-1)
Dimensions to be listed in order of A, D
(not compatible with IE 10)
Tapered Reducing Lateral
(Standard L-1-R)
Dimensions to be listed in order of A, B, D
30° Lateral
(L-1-30)
Dimensions to be listed in order of A, D
Saddles
Available with or w/o boot
Dimensions to be listed in order of D, P Standard boot has 2″ perimeter around branch.
Field Installation of Saddle Tap on Spiral Pipe
TOOLS NEEDED:
Saddle
Hammer
Screwdriver
Marker
Tek Screws
Foil Tape
Duct Seal
Screw Gun
OPTIONAL:
Sawzall or snips
Optional 45° Reducing Laterals, 45° Double Parallel Laterals & Reducing Lateral Crosses
Available in any angle
Optional 45° Reducing Lateral
(O-L-1-R)
Dimensions to be listed in order of A, B, D
45° Double Parallel Lateral
(L-2)
Dimensions to be listed in order of A, C, D
Reducing Lateral Cross
(Full Taper Standard)
(L-2-R) @ 180°
Dimensions to be listed in order of A, B, C, D
Multi-Branch Laterals (Manifolds)
How to Order
To order a multi-branch lateral (or manifold), first give the dimensions of A, B, C, D, E, F, G, etc. Then give the branch angle (45°standard) and the radial angles if needed.
Example 1: 12 x 6 x 3 x 4 x 5 x 6 x 7 with 45° branch angles. All branches at radial angle 0°
Example 2: 8 x 6 x 4 x 4 x 4 x 4 with 45° branch angles. Branches C and E at radial angle 0°. Branches D and F at radial angle 180°.